IBM 9080-M9S Manual page 241

Table 31. Service processor (FSP) cable locations
Drawer Cable
ND4 (top) A
B
ND3 A
B
ND2 A
B
ND1 (bottom) A
B
7. Review the following information to identify the locations where the USB cable connects to the
system node that you are servicing and to the system control unit. Then, reconnect the USB cable
that you removed.
Figure 202. USB Cabling
Table 32. USB Cabling
From
ND1 or ND2: P1-C13-T3
a) Plug the USB cable into the previously identified location in the system node by inserting the cable
into the connector, as shown in the following figure.
Cable Length From
1330 mm (4.36 ft) SC1-P1-T7
1330 mm (4.36 ft) SC1-P1-T9
1110 mm (3.64 ft) SC1-P1-T6
1110 mm (3.64 ft) SC1-P1-T8
855 mm (2.81 ft) SC1-P1-T2
855 mm (2.81 ft) SC1-P1-T4
355 mm (1.16 ft) SC1-P1-T3
355 mm (1.16 ft) SC1-P1-T5
To
SC1: P1-T1
To
ND4-P1-C9-T2
ND4-P1-C10-T2
ND3-P1-C9-T2
ND3-P1-C10-T2
ND2-P1-C9-T2
ND2-P1-C10-T2
ND1-P1-C9-T2
ND1-P1-C10-T2
Memory modules 235