IBM 9080-M9S Manual page 35

Attention: Do not drop or damage the metal connectors on the cable. If the metal
connectors are bent or damaged, they need to be replaced.
3. Refer to the following information to determine the point-to-point cabling for SMP cables.
• If you have a two node system configuration, use Figure 27 on page 29 and Table 2 on page 29
to determine the point-to-point cabling for SMP cables.
Figure 27. Cabling a Two Node Configuration
Table 2. Cabling a Two Node Configuration. Each connection that is shown in the diagram
represents a pair of SMP cables.
Cable
5C
5D
6C
Cable type and length From
880 mm (2.9
ft)
880 mm (2.9
ft)
1005 mm (3.3
ft)
ND1-P1-T1
ND1-P1-T2
ND1-P1-T7
To
ND2-P1-T1
ND2-P1-T2
ND2-P1-T7
Cables 29