Miscellaneous Vrms; Preparing The System - IBM 9080-M9S Manual

Hide thumbs Also See for 9080-M9S:

Table of Contents

Miscellaneous VRMs

Preparing the system to remove and replace a miscellaneous A voltage

regulator module

To prepare the system to remove and replace a miscellaneous A voltage regulator module, complete the

steps in this procedure.

1. Identify the part and the system that you are working on. For instructions, see Identifying a

part (www.ibm.com/support/knowledgecenter/POWER9/p9haj/sal.htm).

Use the blue identify LED on the enclosure to locate the system. Ensure that the serial number of the

system matches the serial number to be serviced.

2. Stop the system. For instructions, see Stopping a system (www.ibm.com/support/knowledgecenter/

POWER9/p9haj/crustopsys.htm).

3. Open the rear rack door, if necessary.

4. Label and disconnect both UPIC cables from the system control unit.

UPIC cable locations are P1-C1-T1 and P1-C2-T1.

a. Remove the white plastic lock (A) from the plug housing.

Figure 248. Removing the UPIC cable lock

b. Push down on the blue cable latch (B) and pull out the UPIC cable from the system control unit.

Show Quick Links

Table of Contents