Preparing The 9080-M9S System Node For Operation After Removing And Replacing A Fan - IBM 9080-M9S Manual

Hide thumbs Also See for 9080-M9S:

Table of Contents

Figure 84. Replacing a fan in the system

Preparing the 9080-M9S system node for operation after removing and replacing a fan

To prepare the system for operation after removing and replacing a fan, complete the steps in this

1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged

into a ground jack or connected to an unpainted metal surface. If not, do so now.

2. If you chose to complete this repair with the power off, using your labels, reconnect the UPIC cables

to the system control unit.

UPIC cable locations are P1-C1-T1 and P1-C2-T1.

a. Ensure that the white plastic lock is pulled back from the plug housing.

b. Plug the UPIC cable (A) into the previously identified location in the system control unit by

inserting the cable into the connector until it locks into place.

Show Quick Links

Table of Contents