Preparing The System For Operation - IBM 9006-22C Installing And Configuring

DANGER: Multiple power cords. The product might be equipped with multiple AC power cords
or multiple DC power cables. To remove all hazardous voltages, disconnect all power cords and
power cables. (L003)
(L005)
CAUTION: Hazardous energy present. Voltages with hazardous energy might cause heating
when shorted with metal, which might result in splattered metal, burns, or both. (L005)
6. Place the system into the service position. For instructions, see "Placing an 5104-22C, 9006-22C, or
9006-22P system into the service position" on page 117.
CAUTION: Do not place any object on top of a rack-mounted device unless that rack-mounted
device is intended for use as a shelf. (R008)
(L012)
CAUTION: Pinch hazard. (L012)
7. Remove the service access cover. For instructions, see "Removing the service access cover from an
5104-22C, 9006-22C, or 9006-22P system" on page 115.
Preparing the 5104-22C, 9006-22C, or 9006-22P system for operation after
you remove and replace internal parts
To prepare the system for operation after you remove and replace internal parts, complete the steps in
this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover. For instructions, see "Installing the service access cover on an
5104-22C, 9006-22C, or 9006-22P system" on page 116.
Common procedures for servicing or installing features in the 5104-22C, 9006-22C, or 9006-22P system 107