Installation; Change Hand Of Lock; Change Hand Of Latch - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
3

Installation

a

Change Hand of Lock

Note:
Red surface of locking piece must face secure
(keyed/locked) side of door.
To rotate locking piece:
1. Position lockbody with red surface of locking
piece visible.
2. Insert flat blade screwdriver into locking piece
slot to rotate locking piece.
3. Push locking piece toward back of lockbody
and rotate 180° until red surface shows on
opposite side.
b

Change Hand of Latch

Note:
Beveled surface of latch must face strike. Deadlatch is self-adjusting.
To change hand of latch:
1. Insert flat blade screwdriver into spade
shaped slot. (Figure 3)
2. Rotate screwdriver 90º to push latch out until
back of latch clears lock front; rotate latch
180º. Latch will re-enter lockbody.
Left Hand
Left Hand
Reverse Bevel
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Door Handing
Inside
Outside
Inside
Outside
Door hands determined from outside (Secured/Keyed side)
Figure 5
Note:
Red color indicates locked side of door.
Locking Piece Slot
Figure 2
Spade
Shape Slot
Lock Front
Latch
Figure 3
4
Figure 4
Right Hand
Right Hand
Reverse Bevel
FM468 03/20