English Contents Dear Customer, Guide to Using this Manual Safety Precautions and Working Thank you for choosing a quality engineered STIHL product. Techniques Assembling the Unit It has been built using modern Controls production techniques and comprehensive quality assurance. Preparing Unit for Operation...
Safety Precautions and injury to third parties or damage to their Working Techniques property. This instruction manual covers a STIHL Do not lend or rent your sprayer without Pictograms sprayer which is also referred to as the the instruction manual. Be sure that unit in the descriptions.
Page 5
Wear proper protective clothing and Only use parts and accessories that are injuries, wear snug-fitting equipment when using, filling and explicitly approved for this tool by STIHL safety glasses in accord- cleaning the sprayer. Follow the or are technically identical. If you have...
Page 6
– instructions – incorrect mixtures protected from frost. shade may produce toxic fumes or in direct sunlight explosive solutions. – Stand the sprayer on a level surface – – do not fill the tank above the maximum mark. SG 31...
Page 7
Never work on a ladder or any other servicing dealer. insecure support. STIHL recommends the use of genuine When working in open ground and STIHL replacement parts. They are gardens take special care to avoid specifically designed to match your harming small animals.
(2). Connect the hose (1) to the solution container (3). Thread the ends of the strap through the buckle. Connect the wand (4) to the spray gun (2). Shoulder strap Pull the buckle off the shoulder strap. SG 31...
The higher the pressure in the container, solution container – rotate the higher the piston manometer rises – counterclockwise maximum operating pressure is 3 bar. If the maximum operating pressure is exceeded, the relief valve in the piston manometer releases the excess pressure. SG 31...
Page 10
(2) is unlocked and can be Wand Extension operated. Loosen the union nut (1). Pull the wand extension (2) out to the required length and line it up – nozzle orifice facing down. Tighten down the union nut (1) firmly. SG 31...
(1) up and down several times until piston manometer (2) shows a pressure of 2 bar (29 PSI). The pressure in the tank must not drop any more than 0.5 bar (7.25 PSI) within the next 30 minutes. SG 31...
0.5 bar (7.25 PSI) , restore it by operating the pump handle. Pour thoroughly mixed spray solution through the opening (arrow) – do not exceed maximum capacity (check max mark on scale). Screw the pump into the tank. SG 31...
Pull the pump handle (1) out of the cylinder barrel (2) as far as stop. Pull pump handle and rotate it counterclockwise until the gland (3) is released from the cylinder barrel. Pull the piston rod (4) out of the cylinder barrel. SG 31...
Page 14
(2) into the cylinder barrel (3). with sealing ring (5). Hold the gland (1) steady with your thumb and push it into the cylinder barrel. Unscrew the handle (1) from the spray gun and take out the filter (2). SG 31...
Page 15
English Rinse out all parts under running water and then reassemble. SG 31...
Clean nozzle / spinner insert and/or filter tank OK Liquid entering the pump Valve disk dirty or damaged Clean or replace valve disk Piston manometer indicates no tank Piston manometer faulty Replace the unit pressure; relief valve operates too soon SG 31...
Take the product, Directive 2006/42/EC. replacement parts which have been accessories and packaging to an approved by STIHL for this power tool or approved disposal site for environment- Technical documents deposited at: are technically identical. Only use high- friendly recycling.