Motorola MTP850 Ex Product Information Manual page 256

3-150
30.4.4 Powered down
When the terminal is powered down, and subject to the "Powered down" Trigger Enable settings, it
will acquire its location and send a Location Report before performing the power down sequence.
Note: The terminal will not necessarily succeed in transmitting the Location Report before it has to
power off.
30.4.5 Emergency
Upon entry into the Emergency Mode, and depending on the "Emergency" Trigger Enable settings,
the terminal will acquire its position and send a Location Report.
Note: This requirement does not imply that any other reports are inhibited during Emergency, so
any other reports caused by other requirements will still be sent, including immediate
requests over the air, delta distance, and so forth.
30.4.6 Status
If sending an outgoing Status message via the menu, the terminal shall acquire its location and send
a Location Report, provided that some additional settings in Status Id List and GPS Status Value
List are configured accordingly.
30.4.7 TXI ON
Immediately before entering Transmit Inhibit Mode, and subject to the "Transmit Inhibit Mode ON"
Trigger Enable settings, the terminal will acquire its location and send a Location Report.
Note: This requirement will not cause an indefinite delay in entering Transmit Inhibit Mode, since
the maximum acquisition time is specified.
Note: The lower layers of the protocol stack may lose the report, due to Transmit Inhibit Mode
activation.
30.4.8 TXI OFF
Immediately after leaving Transmit Inhibit Mode, and subject to the "Transmit Inhibit Mode OFF"
Trigger Enable settings, the terminal will acquire its location and send a Location Report.
30.4.9 TMO ON
Immediately after entering TMO, and subject to the "TMO ON" Trigger Enable settings, the terminal
will acquire its location and send a Location Report.
30.4.10 DMO ON
Immediately before entering DMO, and subject to the "DMO ON" Trigger Enable settings, the
terminal will acquire its location and send a Location Report.
30.4.11 Low Battery
When the terminal battery level is low, and subject to the "Low Battery" Trigger Enable settings, it
will acquire the location of the terminal and send a Location Report.
6866588D21-D Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual
Customer Programming Software (CPS)
March 2009