Table of Contents
Advertisement
Mobility and System Parameters
29
Mobility and System Parameters
These menus are used for programming the terminal with the necessary system parameters that will
enable the terminal to work on the system.
This contains the following menus, of which the Frequency List menu has several sub menus.
29.1
Frequency List
This contains the following four frequency lists:
29.1.1
Frequency List 1
Displays a dynamic list of discrete frequencies that the terminal scans to find a valid TETRA system.
This list is maintained internally by the unit's embedded software only.
29.1.2
Frequency List 2
This list contains up to 32 valid cell frequencies for the system(s) to which the terminal has access.
Frequencies must be entered here to enable first time rapid access to a system. If no frequencies
were entered, the terminal would use the comprehensive hunt feature of lists 3 & 4 if enabled.
March 2009
Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual
3-137
6866588D21-D
Advertisement
Table of Contents
