Table of Contents
Advertisement
3-148
30.3.2
Delete All OTA LRRP Location Report Requests
This field is responsible for removing all Over-the-Air (OTA) Location Request/Response Protocol
(LRRP) report requests (triggered requests) received over the air. This is a clean up measure to
delete orphaned requests that are no longer useful.
To clear all requests, press the Reset button.
30.4
LIP Triggers
Triggering of location reports can be caused by various different reasons, and for each such reason
there will be a corresponding set of values for the related parameters (called the corresponding LIP
Triggers).
If a triggered request has been received over the air, the report will be using the parameters sent
over the air, so the pre-programmed values in CPS will not apply.
The triggers have some of the following settings:
Enabled
Enables/disables the GPS Event Location.
The options are:
•
Enabled - Location reporting on occurrence of this event is enabled (subject to other codeplug
settings).
•
Disabled - Location reporting on occurrence of this event is disabled.
To assign a setting, put the pointer into the field value, click on the arrow, and drag the pointer to the
desired setting.
Max Reporting Interval
This is the interval at which periodic Location Reports are sent.
Type in the value. This value will be mapped to an actual value as shown in the second column of
the mapping table.
6866588D21-D
Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual
Customer Programming Software (CPS)
March 2009
Advertisement
Table of Contents
