Table of Contents
Advertisement
3-66
Full-Duplex.
18.2.15 Emergency SDS Status Destination
This field defines the destination address for the SDS status. The address is either GSSI or ISSI.
Type in the required value.
Applicable if TMO Emergency Services is set to Emergency SDS Status.
18.2.16 Emergency SDS Status Value
This field defines the SDS status value to be sent upon pressing the emergency button/footswitch.
Applicable if TMO Emergency Services is set to Emergency SDS Status.
18.2.17 Emergency SDS Alias
This field defines the SDS status alias displayed on the user's terminal upon pressing the
emergency button/footswitch.
Applicable if TMO Emergency Services is set to Emergency SDS Status.
18.2.18 Disable Visible and Audible Indication
This field is for enabling or disabling audible and visible indication upon pressing the emergency
button/footswitch. This field is not applicable for an outgoing Emergency Private call.
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
18.2.19 Colored Emergency
When an Emergency Call is initiated, the red color screen provides an extra emphasis to alert the
initiating user that the call has been initiated and the receiving users that an Emergency Call is in
progress. The feature can be disabled for a more discreet form of emergency where the display will
be in normal color.
18.2.20 Emergency DMO to TMO
Sets the behaviour of the MS when user enters Emergency Mode in DMO:
•
The MS will stay in DMO Emergency.
•
The MS will go into TMO Emergency after attaching to preselected TMO group: "Default TMO
TG Index Emergency DMO to TMO".
Turn the check box on (Enable) or off (Disable) by clicking in the check box.
18.2.21 Emergency Alarm on Service Recovery
This field defines the number of times the radio sends emergency alarm when the radio returns to
RF coverage; for cases where the emergency button was pressed when the radio was out of
coverage and the emergency alarm could not be sent.
•
Once - Upon the radio returning to RF coverage, an emergency alarm is sent once. On
subsequent loss and recovery of service, no emergency alarm will be sent.
•
Always - Emergency alarm is sent every time the service is recovered.
To change the setting, select the field value, and select the desired setting.
6866588D21-D
Chapter 3 - MTP850 Ex/MTP810 Ex Product Information Manual
Customer Programming Software (CPS)
March 2009
Advertisement
Table of Contents
