Operating The System - Game ready GRPro 2.1 CONTROL UNIT User Manual

To operate your GRPro 2.1 System, you need:
Control Unit filled with ice and water as indicated by the fill line labels within the
•
reservoir. Optimal performance is achieved by first adding 1.5 liters of water, and then
filling the reservoir to the top with ice.
Game Ready supplied power supply.
•
Connector Hose.
•
Wrap (includes a Heat Exchanger and Sleeve).
•
Notes:
The Wrap is comprised of an inner Heat Exchanger and an outer Sleeve. The combination
•
of Sleeve and Heat Exchanger is referred to throughout this manual as a "Wrap. " To ensure
proper performance, be sure to use ATX Series Heat Exchangers.
The Control Unit should be placed on a stable surface (such as the floor or a table) during
•
use.
Note that using the system in an environment with a high ambient temperature may
•
affect its ability to provide adequate cooling, or may limit the ice life.
If you will be using the system with a Game Ready optional battery pack (sold separately),
•
please consult the instructions for use that accompany that battery pack.
Priming the Wrap:
To prevent 04 errors at the beginning of therapy, it is important to prime the Wrap before a
therapy.
With the GRPro 2.1 Control Unit off, attach the Connector Hose to the Control Unit
•
and the Wrap
Lay the Wrap open and flat next to the Control Unit (not on the body)
•
Turn the System on and run for 2 minutes with No Pressure
•
The wrap is now ready for use and therapy may begin as instructed
•
Wrap priming instructions may vary depending on Wrap. Refer to the Wrap Use Guide
included with each Wrap for specific priming instructions.
Warning:
Your GRPro 2.1 Control Unit should be plugged into a grounded electrical outlet
•
prior to operation when using the FSP Power Supply. When using the Mega MDM-
030-A120-5396 power supply, a grounded electrical outlet is not required.
Position the Control Unit to minimize the risk of tripping over the Control Unit, Connector
•
Hose, or power cord.
Precautions:
Failure to properly follow the instructions of this manual and those of your medical
•
provider may interfere with or prevent delivery of appropriate therapy.
To avoid risk of electrical shock unplug the Control Unit from the electrical outlet prior to
•
filling the Control Unit with ice and water.
Push the door release button to open the reservoir door.
1
EN- 8

OPERATING THE SYSTEM