Maintenance And Service Safety Instructions And Practices - Schulte SMR-800 Operator's Manual

Multi-rake

Table of Contents

Secure the Implement for transport before traveling on public roads. For pull-type

Implements, secure the center axle using cylinder stops or transport pin and properly attach

a safety chain between the Implement and Power Unit. Secure wings in upright position on

folding Implements using wing transport locks.

Raise the unit to the transport position and secure with the retaining pins before traveling

on public roads and when storing.

MAINTENANCE AND SERVICE SAFETY INSTRUCTIONS AND

PRACTICES

Relieve hydraulic pressure prior to doing any maintenance or repair work on the Implement.

Place the Implement on the ground or securely blocked up. Turn off the engine. Push and

pull the Remote Cylinder lever in and out several times prior to starting any maintenance or

repair work.

Always maintain the safety signs in good readable condition. If the safety signs are missing,

damaged, or unreadable, obtain and install replacement safety signs immediately.

Do not modify or alter this Implement.

Implement, any of its components or any Implement function.

Never work under the Implement, the framework, or any lifted

component unless the Implement is securely supported or blocked up

to prevent sudden or inadvertent falling which could cause serious

injury or even death.

Periodically inspect all moving parts for wear and replace when

necessary with authorized service parts. Look for loose fasteners, worn

or broken parts, and leaky or loose fittings. Make sure all pins have

cotter pins and washers. Serious injury may occur from not maintaining

this machine in good working order.

SMR-800 04/19

SAFETY

(STL-15)

Do not permit anyone to modify or alter this

(SG-14)

(SG-21)

Safety Section 1-11

(SG-5)

(SG-8)

Table of Contents