G&G IMAGE M4100 Series User Manual page 53

7. Input computer password and click "Install Software".
8. Click "Continue Installation" on the prompt window popping out.
9. The system will finish driver installation automatically.
• If using a USB cable to connect a computer with a Wi-Fi model printer, a wireless network
configuration prompt window will pop up during driver installation, as shown in following picture.
Note: • click "Yes", you can configure printer's wireless network via wireless network
configuration tool (refer to
configuration is completed, unplug USB cable, and then on the pop-up "Add Printer"
interface, you may add the network-connected printer(refer to
add printer).
• Click "No", you can add a USB-connected printer on the pop-up "Add Printer"
interface (refer to
If using a USB cable to connect a computer with a non-Wi-Fi model printer, a "Add Printer"
interface will pop up during the driver installation and you can add a printer here (refer to
3.3 for how to add printer).
Chapter 5.1.1 for how to make configuration).When
Chapter 3.3 for how to add printer).
Chapter 3.3 for how to
Chapter
42