Adding The Controller To An Existing Unixware; System - Adaptec 2025ZCR Installation Manual

Adding the Controller to an Existing UnixWare 7 System
In this scenario, you are adding an Adaptec RAID controller to an
existing UnixWare 7 system. To install the driver
1
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
2
Download the latest I
SCO Web site—it should be
3
Uncompress the PTF file you downloaded in
the file to the
4
Use the
pkgadd
pkgadd -d /tmp/ptf7066c
5
Follow the on-screen prompts to install the SCO UnixWare I
supplement.
6
Shutdown and restart the system.
Note: Upon restarting, several warning messages may
appear and scroll off the screen quickly. These will not occur
after
diskadd
7
Use the
diskadd
to an Adaptec RAID controller.
8
If you need to add devices to a secondary controller, open a
terminal window and type sdiconfig -l. This utility
returns the device address for all controllers recognized by the
operating system and any attached devices. (You will need this
information to perform
format cCCbBBtTTdDD, where
CC specifies the controller ID.
I
BB is the controller channel (or bus) number of the bus to
I
which the disks are attached. The range is 0 - 7.
TT is the target ID (TID). The range is 0 - 31.
I
DD (the second "D") is always zero.
I
O supplement for UnixWare 7 from the
2
ptf7066c
directory.
/tmp
utility to install the I
is run and can be ignored.
utility to add drives or arrays that are attached
Step
Chapter
or higher.
O supplement by typing:
2
9.) The device address is of the
Installing the Driver
2.
Step 2 and move
2
3-29
O