Changing The Driver In An Existing System - Adaptec 2025ZCR Installation Manual

Adaptec RAID Installation Guide
3
Restart the system and open the Control Panel. Click the SCSI
Adapters icon. Then select the Drivers tab and click Add.
4
Insert the driver disk you created in
Disk.
5
Select Adaptec I
6
After the driver is loaded, shut down the system.
7
Replace the existing controller with the Adaptec RAID
controller. For installation details, refer to
8
Start up the system.
9
If you are removing the old controller, you should also remove
the old driver. To do so, open the Control Panel, click the SCSI
Adapters icon, and then select the old driver and click
Remove.

Changing the Driver in an Existing System

In this scenario, you are changing the driver in an existing
Windows NT 4.0 system that already has an Adaptec RAID
controller installed. To change the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive.
b
Start from the CD. The CD loads a Linux kernel that is used
to manage all of its functions.
c
Follow instructions and respond to prompts as necessary to
get to the Adaptec splash screen.
d
When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
2
Shut down the system and remove the Adaptec RAID
Installation CD and the driver floppy disk.
3
Restart the system and open the Control Panel. Click the SCSI
Adapters icon. Then select the Drivers tab and click Add.
3-10
O RAID Host Adapter Driver for NT 4.0.
2
Step 1 and then click Have
Chapter 2.