Upgrading Windows 95 To Windows 98/Me (Upgrade Version); Novell Netware; Caution: When Adding A Zero Channel Raid (Zcr); Controller To An Existing System, Backup All Data From - Adaptec 2025ZCR Installation Manual

Upgrading Windows 95 to Windows 98/Me (Upgrade Version)

If you are upgrading the system from Windows 95 to
Windows 98/Me in an existing system that already has a
functioning Adaptec RAID controller, no further configuration is
necessary. Perform the Windows upgrade; the functionality of the
Adaptec RAID controller is retained.
If the controller is being added in addition to the upgrade, follow the
procedure in Installing the Driver in a New Windows 98/Me System on
page 3-13.

Novell NetWare

The Adaptec RAID Installation CD contains device drivers for
NetWare 4.11, 4.2, and 5.x. The following Novell support packs are
the minimum level required before installing Adaptec RAID
controller software and drivers:
After you have installed the drivers, you can use the normal
NetWare procedures for modifying disk partitions, applying hot
fixes, or performing volume maintenance.
!

Caution: When adding a Zero Channel RAID (ZCR)

controller to an existing system, backup all data from

system drives prior to the installation. If the boot device is
connected to one of the onboard SCSI channels, the
operating system will need to be reinstalled after installing

the ZCR controller.

NetWare Revision Level
4.11 or 4.2
5.0
5.1
Installing the Driver
Support Pack
8a
5
1
3-19