Adaptec 2025ZCR Installation Manual page 51

Adaptec RAID Installation Guide
14
Open the Device Manager. Look for a PCI Card entry under the
Other Devices category. There may be multiple entries if you
have multiple Adaptec RAID controllers installed. There may
also be an entry called PCI Memory Controller.
15
Select PCI Card and then select Update Driver from the Driver
tab.
Note: If you are not prompted for a PCI card or memory
controller driver, or if the Device Manager shows PCI Card
with a yellow exclamation mark in the Other Devices list,
you might need a patch for your motherboard chipset to
recognize multifunction bridge controllers. Contact your
motherboard vendor and apply the patch. After the patch is
installed and the system is restarted, Windows will repeat
the device discovery process. If you are installing the
operating system, go back to
procedure. If you are adding an Adaptec RAID controller to
an existing configuration, go to
continue the procedure.
16
Insert the driver disk you created earlier (refer to
and let Windows search for the drivers.
17
Windows should identify the PCI card as Adaptec I
Host Adapter. Select Finish. At this point, you might need to
force Windows to copy the driver from the floppy drive
instead of the CD drive.
18
When prompted regarding testing the device ROM, select
Cancel.
19
Open the Device Manager. If the Other Devices category shows
a PCI memory controller, select it, click the Driver tab, and
select Update Driver.
20
Let Windows search for the drivers on the disk your created
earlier (refer to
21
Windows should now identify the PCI memory controller as
Adaptec I
2
might need to force Windows to copy the driver from the
floppy drive instead of the CD drive.
3-16
page 3-11).
O Memory Adapter. Select Finish. At this point, you
Step 14 and continue the
Step 6 on page 3-18 and
page 3-11)
O RAID
2