Windows 95, Windows 98, And Windows Me - Adaptec 2025ZCR Installation Manual

4
Insert the driver disk you created in
Disk.
5
Select Adaptec I
6
After the driver is loaded, shut down the system.
7
Install and configure the Adaptec RAID controller and hard
drives according to the instructions in
existing controller installed.
8
Start up the system.

Windows 95, Windows 98, and Windows Me

The following installation scenarios are discussed:
Installing the Driver in a New Windows 98/Me System on
I
page 3-13
Installing the Driver in a New System with Windows 95 (OEM SR2
I
- Version 95B) on page 3-15
Adding the Controller to an Existing Windows 95/98/Me System on
I
page 3-17
Upgrading Windows 95 to Windows 98/Me (Upgrade Version) on
I
page 3-19
!
Caution: When adding a Zero Channel RAID (ZCR)
controller to an existing system, backup all data from
system drives prior to the installation. If the boot device is
connected to one of the onboard SCSI channels, the
operating system will need to be reinstalled after installing
the ZCR controller.
O RAID Host Adapter Driver for NT 4.0.
2
Installing the Driver
Step 1 and then click Have
Chapter 2. Leave the
3-11