Upgrading The Controller In An Existing System - Adaptec 2025ZCR Installation Manual

7
You are prompted to either press S to specify additional
controllers or press Enter to continue Windows NT installation
without specifying additional controllers.
Press S to Specify Additional Devices. Select Other, then insert
the driver disk you created in
8
Select Adaptec I
9
Press Enter and continue with the installation according to the
instructions in the Windows NT documentation.

Upgrading the Controller in an Existing System

In this scenario, you are removing a controller from a working
Windows NT 4.0 system and substituting an Adaptec RAID
controller.
Note: If you have already installed an Adaptec RAID
controller in your system and want to change drivers, refer
to Changing the Driver in an Existing System on page 3-10
instead of this procedure.
To install the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive.
b
Start from the CD. The CD loads a Linux kernel that is used
to manage all of its functions.
c
Follow instructions and respond to prompts as necessary to
get to the Adaptec splash screen.
d
When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
2
Shut down the system and remove the Adaptec RAID
Installation CD and the driver floppy disk.
Step
O RAID Host Adapter Driver for NT 4.0.
2
Installing the Driver
1.
3-9