Server; Installing The Driver For A Boot Controller In A New Netware 5 Server - Adaptec 2025ZCR Installation Manual

13
Select Edit startup.ncf. If needed, edit the file so that
is listed before
14
Shutdown and restart the server.
Installing the Driver for a Boot Controller in a New
NetWare 5 Server
In this scenario, you are installing the Adaptec RAID controller as a
boot controller in a new NetWare 5 server. To install the driver
1
Create a driver floppy disk using the Adaptec RAID Installation CD.
To create the disk
a
Insert the Adaptec RAID Installation CD in your drive and a
blank floppy disk in the floppy disk drive.
b
Copy all the files in
disk.
c
Remove the Adaptec RAID Installation CD and the driver
floppy disk.
2
Install the Adaptec RAID controller as the primary controller
and attach the disk drives.
3
Start up the server. During restart, press Ctrl+A to start SMOR.
Use SMOR to create the RAID. For details, refer to
SMOR on page
4
Install and configure a secondary controller, if any.
5
Create a directory on the
6
Insert the driver disk you created in
7
Copy to
a:\
8
Start the NetWare installation program from the CD.
9
On the Server Drivers – Summary menu, highlight Disk and
CD-ROM Drivers and press Enter.
10
When prompted select i2opci.nlm and bkstrosm.ham as
drivers.
11
Complete the NetWare installation according to the Novell
documentation.
bkstrosm.ham
\packages\netware\5.x\driver
2-11.
C
.
c:\nwupdate
in your
startup.ncf
drive named
nwupdate
Step 1.
Installing the Driver
i2opci.nlm
file.
to the floppy
Using
.
3-25