Adaptec 2025ZCR Installation Manual page 38

c
Follow instructions and respond to prompts as necessary to
get to the Adaptec splash screen.
d
When you see the Adaptec splash screen, click Create
Driver Disk. Then, click the appropriate operating system.
e
Insert a floppy disk and click OK. The system creates the
driver disk.
3
Shut down the system and remove the Adaptec RAID
Installation CD and the driver floppy disk.
4
Insert the Windows 2000 setup media (floppy disk or CD) and
restart the system to begin the Windows 2000 installation.
5
When the Windows 2000 installation starts, a blue screen
appears after the hardware detection message. When
prompted to install a third-party driver, press F6
Note: You only have 5 seconds to press the F6 key during the
installation startup. A prompt appears at the bottom of the
screen when F6 is active. Press F6 at this time; otherwise,
you must restart the Windows 2000 installation process to
complete this procedure correctly.
6
When Windows 2000 starts for the first time, it launches the
Found New Hardware Wizard. Click Next. Then, select Search
for suitable driver for my device and click Next again.
7
Insert the driver disk you created in
disk and click Next. The wizard should find the Adaptec RAID
Adapter.
8
Click Next and follow the instructions. Eventually, the
installation will require that the system shut down and restart.
After the restart, respond to any further instructions as needed
to complete the installation.
Installing the Driver
.
Step 2. Select the floppy
3-3