Adaptec 2025ZCR Installation Manual page 49

Adaptec RAID Installation Guide
11
During one of the device detection start processes, Windows
identifies a PCI Card device. Click Next and display the list of
drivers from a specific location.
Note: If you are not prompted for a PCI card or the Device
Manager shows PCI Card with a yellow exclamation mark in
the Other Devices list, you might need a patch so that your
motherboard chipset recognizes multifunction bridge
controllers. Contact your motherboard vendor and apply
the patch. After the patch is installed and the system is
restarted, Windows repeats the device discovery process. If
you are installing the operating system, go back to
and continue the procedure. If you are adding an Adaptec
RAID controller to an existing system, go to
page 3-18
12
When prompted, insert the driver disk you created
and select Have Disk. The system restarts.
Note: If more than one Adaptec RAID controller is installed
in the computer, repeat Steps
13
Open the Device Manager. Select the SCSI and RAID
Controllers icon. The Device Manager should now show an
Adaptec I
2
14
Optional: Using a text editor, remove the
your
autoexec.bat
procedure, these
longer be needed.
3-14
and continue with the procedure.
O RAID Host Adapter.
file. When you complete the installation
config.sys
11 and 12
mscdex
and
autoexec.bat
Step 11
Step 6 on
(page
for each controller.
entry from
file entries may no
3-11)