Preparations Before Filling; Filling And Heating The Machine - Wexiodisk WD-12S Installation And User Manual

Operating instructions

4.1.2 Preparations before filling

Check:
•
•
•
•
•
•
•
Remember:
•
•
•
•
•
•

4.1.3 Filling and heating the machine

•
•
•
•
WD-12S
That the machine and removable parts have been cleaned. If not – clean
them!
That no dirt is in the washer arms' (14) or in the rinse pipes' (13) nozzles
That removable parts are correctly in place
Amount of detergent and drying agent (option)
That the stopcock for the water to the machine is open
That the power switch is in the ON position
That the machine's control button ON/OFF (9) is switched on
Ordinary washing-up liquid must not be used in the machine or for soaking.
Contact your detergent supplier regarding the choice of a suitable
detergent. Washing-up liquid causes a build-up of foam, produces poor
wash results and can damage the machine.
Steel wool must not be used for pre-treating the dishware.
Only detergent and drying agent intended for industrial machines may be
used.
If using liquid detergent and drying agent, the same make and type of
detergent and drying agent should be used.
If the machine is designed for glass washing and equipped with a
condensing unit, detergent intended for aluminium should be used.
If the machine is equipped with a condensing unit, dishware should be
removed from the machine as soon as the condensation cycle is complete
so that re-condensation does not occur.
Switch on the power using the 0/1 button (9). Close the hood by pressing
button (5). The display (2) shows the temperature of the rinsing water. The
display (4) shows P0. P0 is a pause mode which indicates that no washing
programme has been selected.
Filling and heating for a standard machine take approx. 20 minutes at an
incoming water temperature of 55° C. The heating time is dependent on the
incoming water temperature. The symbol (3) will light up while the machine
fills with water.
When the machine is full, symbol (1) lights up and the washing temperature
is shown in the display (2). If the washing temperature falls below the set
value by more than 5°C, the temperature shown on the display (2) flashes.
The machine cannot start washing until the set temperature minus 5°C for
the washing water has been reached, if this function is selected. The
normal operating temperature for the washing phase is 60° C. If the
washing temperature falls below 50°C, the temperature display flashes.
29
Rev. (202103)