Wexiodisk WD-12S Installation And User Manual page 27

Installation instructions
Side support for corner-loading
50
A=Connection sink
B=Connection conveyor
The connection profile must look like the one shown in the drawing. The distance
of 6 mm may be reduced, but must not be less than 3 mm.
•
•
•
•
•
Use a spirit level to check that the sinks are horizontal and adjust the height, if
necessary.
WD-12S
A
310486
A
Attach the sink connection to the machine and then adjust.
Drill two ø 4.5 mm holes through the sink connection and the machine,
approx. 100 mm from each outer edge.
Countersink the holes.
Seal with silicone between the connection and the machine.
Secure the sink with countersunk M4 screws, grommets on the outside
surface and nuts. Alternatively, you can secure the sink to the wall with wall
brackets.
23
B
A
6
Rev. (202103)
B
B
6