Changing The Water - Wexiodisk WD-12S Installation And User Manual

Operating instructions

4.2.6 Changing the water

To achieve the best possible washing results, it is important that the water is
changed daily. For normally soiled loads, the water should be changed after
around 30 washes. However, always change the water in the event of foam
problems in the tank.
If IF09 appears on the display, this indicates that the water should be changed.
When the machine is in P0 mode with the hood open and the symbol (1) is lit,
change the water as follows:
Machines without a drain pump
•
•
•
•
•
•
•
•
Machines with a drain pump (option)
N.B! The hood must be open when the drain pump is running.
•
•
•
•
•
•
•
•
•
WD-12S
Check that the machine is in P0 mode.
Open the hood (5).
Open the basket conveyor (16) with grid sections (option) or grid basket
(option) and lock it in place with the clasp (15) at the back edge of the
machine.
Remove the strainer basket (17) and filter tray (11) and clean them.
Empty the machine by turning the level pipe (18) a quarter of a turn
anticlockwise.
When the tank is empty, turn the level pipe (18) clockwise and refit the filter
tray (11) and strainer basket (17).
The basket conveyor (16) with grid sections (option) or grid basket (option)
folds down.
Close the hood (5) and the machine will refill. Check that the final rinse
symbol (3) is lit.
Check that the machine is in P0 mode.
Open the hood (5).
Open the basket conveyor (16) with grid sections (option) or grid basket
(option) and lock it in place with the clasp (15) at the back edge of the
machine.
Remove the strainer basket (17), filter tray (11) and the level pipe (18) and
clean them.
Press the 0/1 button (9).
Press P1 (6). One display (2) shows "dP", and the other (4) shows the time.
The drain pump starts and stops after a set time.
When the tank is empty, refit the level pipe (18), filter tray (11) and the
strainer basket (17). The basket conveyor (16) with grid sections (option)
or grid basket (option) are reset to their original positions.
Press the 0/1 button (9).
Close the hood (5) and the machine will refill. Check that the final rinse
symbol (3) is lit.
40
Rev. (202103)