Wexiodisk WD-12S Installation And User Manual page 32

Operating instructions
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
In the following chapter, figures are given in brackets to clarify what needs to be
done. These numbers refer to image and list above.
WD-12S
Symbol for washing function. After the machine is started, the symbol lights
up when the tank is full. The symbol flashes if the water level in the tank is
too low.
Display for temperature during operation. When checking and setting
reference values, the display shows the number for the relevant reference
value, e.g. 01, 02, 03, etc. Together with display (4), it shows error
messages.
Final rinse indicator. The symbol is lit while the machine is filling up, during
the final rinse phase and when the cleaning programme is run after a
completed washing cycle. The symbol flashes if the hood is opened during
the washing cycle or if the correct rinse temperature has not been reached
when the rinsing is due to start.
Display for programme display during operation. If the machine is equipped
with ECO flow, "CO" is shown on the display when this is active. When
checking and setting the reference values, the display shows the relevant
reference value.
Button for opening/closing the hood.
Button for washing programme P1. When the machine is in service mode,
P1 is used to show the different reference values and to reset the reference
values to the last saved values. If the machine has a drain pump, P1 is
used to start the drain pump and empty the tank after washing.
Button for washing programme P2. P2 is used in service mode to increase
a reference value or jump between tables. In shut-off mode the software
version number can be displayed by holding down P2.
Button for washing programme P3. P3 is used in service mode to reduce a
reference value or jump between tables. P3 is used in shut-off mode to start
internal rinsing when the cleaning programme is used to clean the
machine.
Button to switch the power on or off. This button is also used to reset
alarms, display the water flow to the machine and to move to service mode.
Wash tank
Filter tray
Levers (qty. 2) for selecting Normal load (-) and Heavily soiled load (+)
Rinse pipe
Washing arm (qty. 4), removable
Bracket to support basket conveyor (16), with grid section (option) in folded
position.
Basket conveyor, foldable. The basket conveyor may optionally be
equipped with grid sections.
Strainer basket
Level pipe
Pump filter
Rubber sleeve
28
Rev. (202103)