Installation; Preparing For The Installation; Positioning The Machine - Wexiodisk WD-12S Installation And User Manual

Installation instructions

3.4 Installation

3.4.1 Preparing for the installation

3.4.2 Positioning the machine

Check that there is sufficient room for the machine at the installation location.
• Check that correct connections are available for water, electricity, drainage
and possibly steam at the installation location. See TECHNICAL
SPECIFICATIONS.
• Check that the overheating protection device is reset.
Check the following points before the machine is placed in position:
• Check that the fuse for the machine at the site is off, blocked and that
outgoing electrical circuits from the machine are non-live.
• Remove the protective plastic on the sides which are to be stood against a
wall.
• The distance between the wall and machine should be at least 20 mm.
• If the machine is to be corner-loaded, it must be positioned with the control
panel furthest away from the wall.
Put the machine in position and check that the machine and any accessories are
horizontal using a spirit level. Place the spirit level on the join between the
machine tank and the upper part. Adjust the height with the legs.
Check with a spirit level that the machine is horizontal
Once the machine has been filled with water, do another check to make sure the
machine is horizontal.
WD-12S
Inst_plac
11
Rev. (202103)