Table of Contents
Advertisement
Chapter 6 Troubleshooting
Bit Set
None. This bit indicates if any bits in the auxiliary 2 status word are set. The auxiliary 2 word provides
30
status information and does not contain any new information on problems. Refer also to the FRESET
command.
None. This bit indicates if any bits in the auxiliary 1 status word are set. The auxiliary 1 word provides
31
status information and does not contain any new information on problems. Refer also to the FRESET
command.
For information about the commands and logs in this section, refer to the
ence
Manual.
6.2 Examining the AUX1 Status Word
Table 12: Resolving an Error in the AUX1 Status Word below provides actions to take when your receiver has
an error flag in the AUX1 status word.
Bit Set
0-2
Jammer detected
3
None. This bit indicates that Position Averaging is ON
4-6
Jammer detected
7
(Reserved bit)
8-10
(Reserved bits)
11
(Reserved bit)
12
None. This bit indicates a Profile set using the PROFILE command is activated.
Throttled Ethernet Reception
Check for unusually high Ethernet traffic being directed to the Receiver.
13
This does not represent an error condition on the receiver, but suggests there may be an issue in the
network environment on the receiver.
AGC error on RF1 through RF4 respectively.. Contact NovAtel Customer Support on page 10 for
14-17
additional information.
18
Connect the receiver via Ethernet.
19-21
Reduce the amount of logging on the Ethernet ports
22-24
Reduce the amount of logging on the NTRIP ports
25-27
Reduce the amount of logging on the Virtual COM ports
AGC error on RF5 (bit 28) or RF6 (bit 29).. Contact NovAtel Customer Support on page 10.for additional
28-29
information.
30-31
(Reserved bits)
SMART2 Installation and Operation Manual v4
Table 12: Resolving an Error in the AUX1 Status Word
Action to Resolve
Agriculture Commands and Logs Refer-
Action to Resolve
47
Advertisement
Table of Contents
