Mounting Plate - Novatel SMART2 Installation And Operation User Manual

Chapter 2 SMART2 Installation
The SMART2 must be rigidly secured to the vehicle to avoid errors caused by vibration and
motion.
If installing in a stationary location, mount the SMART2 in a location that has a clear view of the sky so that
l
each satellite above the horizon can be tracked without obstruction.
The SMART2 can be mounted to the vehicle using the integrated magnets, an optional mounting plate or four M4
screws.
The optimal screw penetration into the SMART2 mounting holes is 6 mm (±1 mm) deep. When select-
ing screws for mounting the SMART2, ensure the screw penetration does not exceed this specification.
Using excessively long screws can damage the SMART2 enclosure.

2.1.1 Mounting Plate

Two mounting plates are available to facilitate mounting the receiver:
a surface mounting plate
l
a pole mounting plate
l
Refer to SMART2 Mechanical Specifications on page 66 for mounting plate and pole mounting dimensions.
Surface Mounting Plate
To install the surface mounting plate:
1. Place the SMART2 on the surface mounting plate. The alignment pins on the mounting plate seat in the two
of the SMART2 mounting holes.
2. The integrated magnets will hold the SMART2 on to the mounting plate.
To secure the SMART2 to the mounting plate, use two M4 screws that pass through the mounting plate and
into the SMART2. Torque the screws to 10 – 12 in-lbs.
SMART2 Installation and Operation Manual v4
Figure 4: Orienting SMART2
17