Smart2 Notices - Novatel SMART2 Installation And Operation User Manual

SMART2 Notices

SMART2 Notices
The following notices apply to the SMART2 devices (model dependent).
Changes or modifications to this equipment, not expressly approved by NovAtel Inc., could void the
user's authority to operate this equipment.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
SMART2 has been tested and found to comply with the radiated and conducted emission limits for a Class B
digital device. The Class B limits are designed to provide reasonable protection against harmful interference in a
residential installation.
The equipment listed generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Re-orient or relocate the SMART2
l
Increase the separation between the equipment and the SMART2
l
Connect the equipment to an outlet on a circuit different from that to which the SMART2 is connected
l
Consult the dealer or an experienced Radio/TV technician for help
l
The SMART2 has been authorized for use in Mobile applications. At least 20 cm (8 inches) of sep-
aration between the SMART2 and the User must be maintained at all times.
Bluetooth
SMART2-B and SMART2-TB contain a Bluetooth radio with the following approvals:
FCC ID: QOQBT121
l
Innovation, Science and Economic Development (ISED) Canada
SMART2 Class B digital device complies with Canadian ICES-003.
SMART2 appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with ISED license-exempt RSS-GEN and RSS-247. Operation is subject to the following
two conditions: (1) this device may not cause interference and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Cet appareil est conforme à la norme ISED RSS-GEN et RSS-247. Son fonctionnement est soumis aux deux
conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris les interférences pouvant entraîner un fonctionnement indésirable de l'appareil.
SMART2 Installation and Operation Manual v4 6