PIONEER DJ DJM-S11 Instruction Manual page 39

Channel section
1. Input selector switch
Selects an input sound source.
— [ A,B] : Selects a PC/Mac connected to one of the [USB] ports.
— [LINE] : Selects a multi player, etc. connected to the [LINE] terminals.
— [PHONO] : Selects a turntable connected to the [PHONO] terminals.
TRIM knob
2.
Adjusts the volume for the channel input sound.
HI, MID, LOW knobs
3.
Adjusts the volume of each frequency band.
Each knob adjusts in the following range.
— [HI]: -∞ dB to +6 dB (ISO)/-26 dB to +6 dB (EQ)
— [MID]: -∞ dB to +6 dB (ISO)/-26 dB to +6 dB (EQ)
— [LOW]: -∞ dB to +6 dB (ISO)/-26 dB to +6 dB (EQ)
Channel fader
4.
Adjusts the volume for the channel output sound according to the channel fader curve
set with the [CH 1 CURVE] or [CH 2 CURVE] knob (page 41). Moving it up increases the
volume, and down decreases the volume.
Slide up from the bottom position while pressing the [SHIFT] button to trigger Channel
Fader Start (page 98).
Channel level indicator
5.
Displays the volume level before the sound passes through the channel fader.
Crossfader
6.
Adjusts the volume balance between the channel output sounds according to the
crossfader curve specified with the [CROSSFADER CURVE] knob (page 42). Moving it
to the CH 1 side outputs the sound of CH 1, and to the CH 2 side outputs the sound of
CH 2.
Slide from either end to the other side while pressing the [SHIFT] button to trigger
Crossfader Start (page 99).
39
Audio output