PIONEER DJ DJM-S11 Instruction Manual page 116

• After you've replaced the bumper, adjust the range where sound is not output at both
sides of the crossfader (page 105).
• You can fix the fader unit by inserting fader bumper A vertically into the grooves (4 in
the diagram above) on both edges of the fader unit as necessary.
6 Attach the aluminum panel, then tighten the six parts with the
screws.
• Check that no parts or dust fell inside the unit before you tighten the screws.
• Do not tighten the screws too much, or you may damage them.
• Be careful not to strip the screw thread (cross-recess) when tightening a screw.
• Never install the screws at an angle, or you may damage the parts.
7 Reattach the seven knobs.
116
Settings