Kubota RT120Q Operator's Manual page 190

RT120Q Operator's Manual
As Needed
8. Loop cable through links nearest connector
pin.
Hot parts may cause burns. Do not touch
until cool or wear gloves.
To help avoid injury: Service digging
boom grease cylinder only while standing
on opposite side of boom. Wear gloves and
safety glasses, and cover fitting with cloth
when relieving pressure in cylinder.
9. Loosen plug on grease cylinder to relieve chain tension.
10. Stand clear of chain and remove lock key from connector pin. Drive connector pin out of link.
11. Unclamp links. Slowly release cable and lower chain to ground.
12. Lay chain on ground with teeth down.
To install chain:
1. Lay chain on ground with teeth down and pointed toward unit.
2. Fasten and adjust seat belt.
3. Start tractor. See page 84 for start-up procedures.
4. Release parking brake and verify parking brake indicator is off.
5. Move ground drive control to reverse.
6. Back unit up until chain extends past head shaft about 1' (305 mm).
7. Move ground drive control to neutral.
8. Lower backfill blade, if equipped, to ground.
9. Lower boom to horizontal position.
10. Set parking brake and verify parking brake indicator is on.
11. Turn ignition switch to STOP.
12. Pull rear end of chain over and about 10" (260 mm) past tail roller.
Crushing weight could cause death or serious injury. Use
proper procedures and equipment or stay away.
Service - 189