Install Product - Kubota RT120Q Operator's Manual

RT120Q Operator's Manual
Operate

Install Product

To install product, pull it through the bore after drilling or final pass of backreaming.
1. Install appropriate swivel (2) to drill string
(1) or reamer. Ensure swivel functions
correctly.
2. Use shackle (3) to attach pipe pulling
adapter (4) or pulling grip (5) to swivel.
3. Attach material to pipe pulling adapter or
pulling grip.
4. Set engine to low throttle.
5. Slowly drive in reverse. See page 85 for
proper driving procedures.
IMPORTANT:
• If bore becomes blocked begin
counterclockwise rotation.
• If length of rod outside the bore
reaches 30' (9 m), remove rod
section. See "Remove Rod" on
page 136.
6. When product exits approach trench, stop machine immediately.
Rotating shaft will cause death or serious injury. Stay
away.
To help avoid injury: Ensure no one is in target trench or near product
being installed. If swivel malfunctions, material can rotate.
Drill - 135