How To Edit The Instruments Of The Motivator - Quasimidi CYBER-6 Manual

How to edit the instruments of the motivator

changing the dynamic individually for each
step
Switching on and off isolated steps without
consideration of the dynamic or the chosen
instrument
In the "Dyna"-mode you can see the dynamic-values of the individual steps as bargraphs. The displayed
height of each bar represents the level of the actual dynamic-value - as you probably may have guessed or
hoped already. Now let´s take a look at another very important part of the editing of the motivator: The
definition of the MIDI-channels and the sounds that are used by the motivator-patterns.
Depending on the selected instrument a motivator-pattern may sound very differently. In the submenu 5
How to edit the
the instruments can be changed. After the selection of the page 5 of the display you should receive the
instruments of the
following message on the display:
motivator
desired input
Selection of one of the 8 instruments
Setting the MIDI-channels for the chosen
instrument
Choosing a program-change-bank
Setting of the program-number
Adjusting the volume
32
Dyna
OnOf
<4>
MOT 1 RHYTHMIC EDIT
<5> MOT 1 INSTRUMENT EDIT
CHAN:A 3 Bank:
parameter
Inst
Chan
Bank
Program
Vol
If you are already content with your choice of
instruments and the rhythmic but like to correct the
dynamic you can do this in the now described
mode. The dynamic of each step can be modified
by pressing down the corresponding key in the grid
with the desired dynamic, the new dynamic-value
is immediately related to the corresponding step.
If you like to modify the structure of the rhythm
without taking into account the definition of the
instruments and the dynamic, you can switch on
and off individual steps in this mode without
influencing the remaining parameters.
Mode:DYNA Inst:
0 Program: 1 Volume:100
Operation/explanation
The choice of an instrument is done with the "+/-"
- buttons.
Once more the setting is done with the help of the
"+/-" - buttons. As you already gotten to know in
the edit-mode of the masterkeyboard-zones you
can use the "INFO"- button for finding an up to
now unused MIDI-channel. Just hold down the
"INFO"- button and press the key on the keyboard
that corresponds to the desired MIDI-channel.
Synthesizers containing more than 128
program-changes usually accept the
bank-change-controller (controller-No. 0). Because
of that controller you can select out of 128 banks,
each containing up to 128 programs.
With this parameter you select the
program-number, that means: the sound of your
synthesizer
With this parameter you determine the
volume-level of the instrument.
1
Inst: 1