The Edit-System-Menu - Quasimidi Technox Owner's Manual

14.) The Edit-System-Menu

The following 4 sub-menus are reserved for the transmission of system-exclusive data via MIDI. System-exclusive
informations are unique to each manufacturer of MIDI equipment; each manufacturer uses its own data format for
describing sound-data and machine-dependent informations. TECHNOX uses system-exclusive data for transferring its
RAM informations to a MIDI sequencer (and vice versa). So you can use your sequencer as an external storage device for
your TECHNOX. The TECHNOX can send and receive SysEx data on 16 different ID-numbers. These ID-numbers are
important because it allows you to use more than only one single TECHNOX in your MIDI setup. The ID-number will be
selected in the „System-Edit" menu. Changing the basic MIDI channel also affects this.
<7>
<8>
<9>
<10>
The System menu is used for the settings of all global parameters. These include the filtering of incoming
14.) The Edit-
and outgoing MIDI data, the global tuning of the TECHNOX and the velocity response characteristics.
System-Menu
You will reach this menu from the main page by doing the following:
Function
Selection of edit level.
Selection of "Edit System" menu.
Confirm selection
Now you have access to the following sub-menus:
|1>
<2>
<3>
<4>
After pressing the „EDIT/OK" key, the TECHNOX sends out all actual settings
<7>\Send\Temp?
via MIDI. This includes all part parameters, the effect settings, the common
Yes<OK>\No<EXIT>
parameters and the arpeggiator settings.
After pressing the „EDIT/OK" key, the TECHNOX sends out all
<8>\Send\Setups?
Sequenzer-multi-setups.
Yes<OK>\No<EXIT>
From here the User-defined drum-sets are sent after pressing the „EDIT/OK" key.
<9>\Send\Drums?
Yes<OK>\No<EXIT>
From here the User-defined drum-sets are sent after pressing the „EDIT/OK" key.
<10|\Send\Perfs?
Yes<OK>\No<Exit>
Here the play mode of the TECHNOX can be altered between the performance-
\\Edit\System
mode and the Sequencer-Multi-mode. Usually the performance-mode is mainly
|1>\Mode:Perform
used for live performances whereas the Multi-mode will be used when working
with a MIDI sequencer. Use the „VALUE/SOUND" dial to toggle the play-mode.
Use this function to select the basic MIDI channel for your TECHNOX. The
\Edit\System
setting of the basic channel is only important when using the TECHNOX in
<2>\Channel:\\\\1
performance-mode. It then receives its MIDI informations on the selected channel.
Note that this channel is also identical to the ID-number of your TECHNOX (see
above: MIDI dump).
This function is used to transpose the TECHNOX in semi-tones (6 steps up or
\\Edit\System
down from C).
<3>\Transpose:\C
Fine-tuning is possible with this function (+63 steps [-1 semi-tone], -64 steps [+1
\\Edit\System
semi-tone]).
<4>\Tune:\\\\\\\+0
User Aktion
(Keys/Dials)
Press "EDIT/OK" key.
Use one of the two Alpha-dials to
select.
Press "Edit/OK" key.
Display-Message
\Edit/Function
\Edit/Function
<7>\Edit\System
\Edit\System
|1>\Mode:Sequenc
QUASIMIDI STYLEDRIVE FANSEITE
http://people.freenet.de/styledrive/
27