Table of Contents
Advertisement
COMPLETE INITIALIZATION
COMPLETE
You should initialize the CYBER -6 completely
INITIALIZA-
TION
1.) When you want to recall the preprogrammed patterns.
2.) When the internal battery was changed
3.) When you´re told to do so by our service department
Since all sequencer patterns and masterkeyboard programs are cleared during the complete initialisation
process, you should save them first with a MIDI dump.
This is how you do it:
procedure of initialization
1.) Turn your CYBER-6 off
2.) Press and hold the "INFO" and the "1" button simultanously while turning the CYBER-6 back on.
3.) This message should appear on your display:
REALLY LOAD PRESET DATA INTO RAM
ENTER: YES / EXIT: NO
4.) Press [ENTER] to initialize or [EXIT9 to abort. After a few seconds the CYBER-6 is ready to play
5.) Calibrate the controllers as described above.
To initialize single memory areas, consult the "Initialization of memory areas" section in this manual.
56
Advertisement
Table of Contents
