Table of Contents
Advertisement
programming the masterkeyboard
As the table shows parameters of masterkeyboard-programs are divided into two areas. The first area is
responsible for all parameters wich can be changed individually for every keyboard-zone. The second
zone is resposible in general for the selected masterkeyboard-program. A different definition for indi-
vidual keyboard-zones is not possible. The consequence for the controller of Cyber 6: you can fix an
active controller for each keyboard-zone. If a keyboard-zone is assigned to midi-channel A 01 and pitch-
bending is activated, Cyber 6 pitch-bending sends on this midi-channel. You can program for the total
masterkeyboard-program wich midi-controller is sent on this midi-channel by using a controller. That is
the reason why it is not possible to sent differet midi-controllers on one controller at the same time, but the
same midi-controller on several midi-channels.
If you feel constricted, consider, that a total free according of all playing aids of each zone contains a Cyber
6´s defile of power of midi-place of intersection. Forgetting this it would be possible to sent 8 different
midi-controllers on one program with one slider at the same time.
Besides, you will get problems with timing. In practice our mode prove it´s worth. It is a compromise
between a rich realtime control and a midi-place of intersection´s restriction of speed caused by the midi
transfer rate.
Selection of
When Cyber 6 is switched on, it is set to the masterkeyboard-mode. If you have searched in the menus of
MIDI-channels
Cyber 6, press exit-key an turn the big page-dial left to reach the masterkeyboard-playmode. The display
and key-window
shows following:
of the keyboard-
zones
Before selecting the masterkeyboard-edit-menu please load program 31 (operation: (31) (Enter) ) This
program is built up very simple and spartanic, thats why it is a good basic to get to know the features. The
display shows following content:
Press "edit-keyb" -button. Now Cyber 6 is in the masterkeyboard-edit menu. You see the selected Menu
page in the first display line at the left side. If it is not dialed yet load it with page-dial of menu 1. The
following display-report appears:
In the first edit page you can choose the synthesizer which will be played at the selected zone. This works
by using different midi-channels for different synths. So you have first to make sure, that all your synthe-
sizers are set to different midi channels. Select the midi-channel [channel] of the desired synthesizer. To
select a different zone, choose the parameter "zone" with the cursor-keys and select one of eight zones
with the "+/-" buttons. We start with keyboard- zone 1. You can select the zone in all edit menus with zone-
refered parameters.
12
|1> CYBER-6
Program 001 Layer
|1> CYBER-6
Program 031 Basic
|1> Keyboard
Channel: A 1
LowKey: C 2
Zone:1
HighKey: C 7
Advertisement
Table of Contents
