Table of Contents
Advertisement
Programming the masterkeyboard
desired input
changing playmode of tone-generator
selecting the zone-status
Please try to use both new parameters. You can imitate the way of playing natural solo-instruments or old
monophonic analog synthesizers. The monophone playmode of this instruments allows technics wich are
not available by using polyphonic playmode.
Selecting the
Now we present the most important function of masterkeyboards. After learning to use the following
program-change
parameters you will be able to program extensive live-setups. Only by selecting another Cyber-6 program
and adjusting the
you will select the desired program-change- and bank-numbers and the volume settings of the connected
volume for the
synths. Select menu-page 3 of the masterkeyboard-edit menu to reach the following display-message:
different zones
Some synths have more than 128 programs. With the program-change command you can only select 128
different voices. For this reason the synthesizer manufactures invited a second midi-message to give the
possibility to choose between different program banks. This Midi-message is called "bank-select com-
mand". Before sending the program-change you have to use the bank-change command to select the de-
sired Program bank.
At the CYBER-6 the parameter "bank" allows the input of a bank-select command. Like the program-
change also the bank-select command has 128 different values. The CYBER-6 always will send the bank-
change automaticly, if you select a new program-change number.
14
parameter
mode
status
<3> Keyboard
Bank:
0
Program:
operation/explaining
Change with +/- keys. Two values are possible:
1.) mono-mode - the synthesizer or part of
synthesizer will be switched to the monophone
playmode.
2.) poly-mode - the synthesizer can be played
polyphon. Not every synthesizer offers the
monophonic playmode.
Change with +/- keys. Three positions are
possible:
1.) play-zone. This status accords to the principal
tuning. Zone can be played with keyboard. Use
this parameter to select a synthesizer.
2.) device/remote: Realtime Controller and
program-changes will be sent. But this zone does
not sent note-informations. Use this tuning for
effect-unit control. Effect program-changes can
be automated.
3.) control-only: In this setting neither notes nor
program-changes will be sent. A zone
programmed like this can be used to control a
motivator. You can also send a controller to a
synthesizer which is played by the sequenzer or
motivator.
Zone:
1
Volume:100
1
Advertisement
Table of Contents
