Table of Contents
Advertisement
Programming the masterkeyboard
desired action
adjusting of keyboardzone
dailing of bank-number
selecting of
program-number
With the next aquired knowledges you will be able to program layer, split- and solo-programs. In the next
chapter you will learn to save your work and to give your programs names
Namingof the
All settings you have changed in the chapters before and also the parameters you will hear about in the
masterkeyboard-
following chapters of masterkeyboard editing could be saved in 128 programs. Nevertheless you don´t
program
know everything about the CYBER-6´s masterkeyboard capabilities it´s useful to learn now, how to save
the changes you made in a new program.
One important information in association with the masterkeyboard programs are the motivator
parameters. They will not be stored automaticly within the masterkeyboard-program. In the mas-
ter-keyboard-program you only select the number of the desired motivator-program. The motiva-
tor-settings have to be stored in the motivator memories. After saving motivator-program, you se-
lect the motivator-program number inside the masterkeyboard-edit menu which will be called by
the the master-keyboard-program.
For better access on stored programs it´s useful to give your programs names. For that reason the first step
in the save procedure is the entry of the desired name. You will find this submenu on page 19 of the
masterkeyboard-edit menu. Select this page with the alpha dial. The following display-message will disap-
pear:
When you select this submenu, you will find the cursor direct at the first character of the name. All you
have to do is to select the character you want to change with the "cursor"-buttons and change the character
with the "+/-"-buttons. Further, you can also change the selected character with the white keys of the
Keyboard. To do this, you must hold the "enter"-button.
When you have noticed the position of the different characters on the Keyboard, the procedure of naming
a program is very fast and much better than using the "+/-"-buttons.
parameter
operation/explaining
volume
Input of volume with +/- keys or directly with number and "enter"
key.
bank
selecting the bank with +/- keys. At Quasar´s GM-mode the first 65
program-change-banks are indentical. A change arise at the 66th
bank-change. This is necessary to get a compatibility with
general-midi´s data format.
program
selecting of program-change with +/- keys or directly with numbers
followed by the "enter" button.
<19> Program-name
(ENHANC 1)
15
Advertisement
Table of Contents
