Table of Contents
Advertisement
Initialisation of memory areas/calibration
Initialization of
With this function you can reset memory areas of the CYBER-6. Move the cursor until the "INIT?" is
the memory
highlighted. With the "+/-"-buttons you can choose the option, which memory-area you want to initialize.
Now you can choose which areas you want to reset:
memory area to initialize
Current masterkeyboard program
motivator1 settings
motivator2 settings
all sequenzer patterns
all masterkeyboard programs plus Motivator
programs
All programmed chains
Kalibrierung der
Use this function to set the realtime-controller ranges and curves. Normally, the factory presets should be
Spielhilfen
ok, except for the external pedals. How should WE know what pedal you´re gonna use ??? After a few
years it might be necessary to change the internal battery of the CYBER-6. Then the calibration settings
are cleared, and you´ll have to calibrate the CYBER -6 again. Before you try to calibrate the controllers
after changing the battery, you have to initialize the entire CYBER-6 first. Please read the "Complete
Initialisation" section in this manual. The submenu for calibration is called from page 5 of the main menu:
Move the cursor, until "CALIBRATION" is highlighted and press [ENTER]. The following submenu
shoukd appear:
The "dynamics" parameter is described in the "Changing the Velocity-curve" section in this manual. For
now, only the lower line on the display is of any interest to us. Pick the "Controller" option and use the "+/
-"- buttons to select the controller to be changed. Then you can enter the lowest and highest values for it
and move on to the next.
52
< 5| INIT/DUMP
Dump:------------
name
act KBD
actMOT1
actMOT2
all PAT
KBD+´MO All masterkeyboard programs and motivator
CHAINS
< 5| INIT/DUMP
Dump:------------
| 1| Calibrate
Controller:
CALIBRATION
Init?
----
description
The current masterkeyboard program will be
resetted. Thus you get a program equal to an empty
one. The original program is not deleted until you
save the initialized. Simply recall the program from
memory.
The settings of motivator 1 are resetted
The settings of motivator 2 are resetted
The entire sequenzer pattern memory is cleared
settings are cleared
All chains are cleared, but NOT the patterns used
therein.
CALIBRATION
Init?
----
Dynamics: LIN
AFTER Value:---
Advertisement
Table of Contents
