Receiving And Storage; Model And Specifications Check; Storage Precautions - YOKOGAWA ADMAG TI Series User Manual

2.

Receiving and Storage

When the product is delivered, check visually that no
damage has occurred during transportation. Also check that
all flowmeters mounting hardware shown below is included.
Integral Flowmeter
Model Part name
AXG### Centering Device (*1)
Blanking Plug
Gasket (sensor side) (*2)
Remote Transmitter
Model Part name
AXG4A Mounting Bracket
Blanking Plug
*1: When the following process connection codes (wafer type)
have been selected, the centering device is attached. AA1, AA2
*2: When the following code is specified for "Lining", gaskets
(sensor side) are attached. The gaskets (customer pipe
side) should be prepared by customers. - Lining code: C
Figure 2.1 Name Plate (AXG Integral Flowmeter)
Figure 2.3 Name Plate (AXG4A Remote Transmitter)
<2. Receiving and Storage>
2.1 Model and Specifications Check
As shown in Figure 2.1 to Figure 2.3, the model, suffix
code, serial number, meter factor, fluid specification,
and device information are found on the name plate
located on the outside of the housing. And, this product
Qty.
can check their information from parameters. Read the
1 set
user's manual of applicable communication type as
1 pcs.
listed in Table 1.1 for checking device information from
2 sheets
parameters.
When checking the matching of model and specification
Qty.
you ordered, see the applicable general specifications as
1 set
listed in Table 1.1.
1 pcs.
Be sure you have the model code and serial number
available when contacting YOKOGAWA.
The model and specification described on the nameplate
are those of the state at the time of shipment.
Note: Description on the nameplate
- Made in _______: Country of origin
- COMB No.: Serial number of the combined remote
sensor or remote transmitter
F0201.ai
Figure 2.2 Name Plate (AXG Remote Sensor)
2.2

Storage Precautions

(Please read the descriptions on IM 01E22A01-01EN.)
F0203.ai
4
F0202.ai
IM 01E21A01-03EN-A