Foundation; Ethernet/Ip Configuration Tool - YOKOGAWA ADMAG TI Series User Manual

5.9 F
OUNDATION
(Not applicable for EtherNet/IP communication type. Please read the descriptions on IM 01E22A01-01EN if
necessary.)
5.10 EtherNet/IP Configuration Tool
The Ethernet configuration can connect with this product
from any connection point of RJ-45.
Port 1 and/or Port2 can be used for plant operation and
maintenance of Ethernet communication.
Module Status
10 100Mbps
/
Network Status
PORT1 Link Activity
PORT2 PORT1 /
PORT2 Link Activity
/
PORT2 PORT1
10 100Mbps
/
Terminal Configuration
NOTE
For maintenance (temporary connection) purpose,
connect RJ-45 Ethernet cable without passing though
the cable hole of device.
Web page can be used for configuration of EtherNet/IP
device. See IM 01E21A02-06EN for details.
Supported software
Operation systems Microsoft Windows 7 or higher
Web browser Internet explorer 8 or higher
Google chrome
Microsoft Edge
fieldbus Configuration Tool
F0514.ai
<5. Basic Operating Procedures>
Product code/name and EDS file for EtherNet/IP
EDS file is required to connect host application tool for
EtherNet/IP (e.g. PLC). If EDS is not installed in the host
tool, download the correct EDS file from ODVA official
web site and install it, or contact respective vendor of the
host tool.
EDS file is separated by the Product code/name. Confirm
the following table to install the correct EDS file.
AXG4A
Vendor ID 250
Vendor Name Yokogawa Electric Corporation
Product Code 201
Product Name AXG4A Magnetic Flowmeter
11
IM 01E21A01-03EN-A