YOKOGAWA ADMAG TI Series User Manual page 3

WARNING
• Purpose of use
This product is the Magnetic Flowmeter for use of
measuring the liquid flow. Do not use this product
for other purposes.
WARNING
• Installation, wiring and maintenance of the magnetic
flowmeter must be performed by expert engineer
or skilled personnel. No operator shall be permitted
to perform procedures relating to installation, wiring
and maintenance.
• Wiring work should be done adequate wire, sleeve
crimp and torque force. Use terminal with insulating
cover for the power supply wiring and protective
grounding wiring. Do not pull the wires too much
strongly in order to prevent electric shocks caused
by their damage.
• Do not open the cover in wet weather or humid
environment. When the cover is open, stated
enclosure protection is not applicable.
• Ensure that the power supply is off in order to
prevent electric shocks.
• When opening the cover, wait for more than 20
minutes after turning off the power. Only expert
engineer or skilled personnel are permitted to open
the cover.
• When opening and closing the transmitter cover, be
sure to handle the transmitter cover carefully so that
there are no damage and foreign matter adhesion at
its threads and O-ring.
• This product employs the parts which are affected
by a function damage caused by static electricity.
Thus, you should do the antistatic work using an
anti-static wrist band for it and be careful to avoid
touching each electrical parts and circuitry directly.
• When connecting the wiring, check that the supply
voltage is within the range of the voltage specified
for this product before connecting the power cable.
In addition, check that no voltage is applied to the
power cable before connecting the wiring.
• To prevent electric shocks, ensure the electrical
wiring cover is completely attached after the wiring
work.
• To prevent electric shocks, do not impress over
rated voltage to each input/output terminals.
• If there is any unused cable entry, use the blanking
plug to cover which comes with this product or
which is supplied by YOKOGAWA. The blanking
plug should be fastened into the unused cable
entry without any mistake. If not, stated enclosure
protection is not applicable.
• To prevent electric shocks, do not remove safety
cover (Read section 3.6).
<1. Introduction>
IMPORTANT
• When closing the cover, close it with both hands
until the cover does not turn in order to bring the
housing and cover into tight contact.
• Tighten while confirming that the cover rotates
smoothly.
(2) Installation
(Please read the descriptions on IM 01E22A01-01EN.)
(3) Wiring
(Please read the descriptions on IM 01E22A01-01EN.)
(4) Operation
(Please read the descriptions on IM 01E22A01-01EN.)
(5) Maintenance
(Please read the descriptions on IM 01E22A01-01EN.)
(6) Modification
(Please read the descriptions on IM 01E22A01-01EN.)
(7) Product Disposal
(Please read the descriptions on IM 01E22A01-01EN.)
(8) Power Supply
Ensure that the source voltage matches the voltage of
the power supply before turning on the power.
Power Supply Code 1:
• AC Type:
Rated Power Supply: 100 to 240 V AC, 50/60 Hz
• DC Type:
Rated Power Supply: 100 to 120 V DC
Power Supply Code 2:
• AC Type:
Rated Power Supply: 24 V AC, 50/60 Hz
• DC Type: Rated Power Supply: 24 V DC
Power Consumption:
Integral Type: 13W
Remote Type (with AXG4A): 13W
(9) microSD Card
(Please read the descriptions on IM 01E22A01-01EN.)
2
IM 01E21A01-03EN-A