Operation; Pre-Operation Zero Adjustment; Zero Adjustment From Display Unit; Hardware Switch Setting - YOKOGAWA ADMAG TI Series User Manual

6.

Operation

6.1 Pre-operation Zero
Adjustment
(Please read the descriptions on IM 01E22A01-01EN.)
6.2 Zero Adjustment from
Display Unit
(Please read the descriptions on IM 01E22A01-01EN.)
6.3

Hardware Switch Setting

NOTE
The integral type is explained as an example. Pay same
attention to the AXG4A remote transmitter.
6.3.1 Integral Type and AXG4A Remote
Transmitter
IMPORTANT
• Removing and installing the cover are necessary
for hardware switches. Perform removing and
installing the cover as described in Section 3.6 of
IM 01E22A01-01EN. When opening the cover,
wait for more than 20 minutes after turning off the
power. This work must be carried out by the trained
personnel having knowledge of safety standard.
• To preserve the safety, do not touch the electrical
circuit and the cables except the setting switches.
• When installing the cover, in order to contact the
housing and the cover, be sure to screw it firmly into
the housing without any space between them.
<6. Operation>
(1) Remove the cover.
(2) While holding the display by hand, loosen the two
mounting screws.
(3) While holding the display by hand (careful for
connecting cable), set the switches. Never remove
connector in this case.
7 6 5 4 3 2 1 0
1
0
ADDRESS
Safety cover
Address switch (ADDRESS)
Enable hardware address switch (SW3-1)
DHCP switch (SW3-2)
Write protect switch (SW1-2)
Figure 6.3.1 Hardware switches
(4) Taking care not to entangle the cables, tighten the two
screws on the display.
(5) Install the cover.
WARNING
To prevent electric shock and maintain performance,
do not remove the safety cover.
NOTE
The hardware switches are adjacent. Special care
should be taken when making switch settings.
Accordingly, special care should be taken when making
switch settings.
12
1 2 1 2
ON
OFF
SW3 SW2
ON
1 2
H
L
SW1
OFF
F0601.ai
IM 01E21A01-03EN-A