Table of Contents
Advertisement
4.4
General operation of display/operation panel
(1) Measurement screen (This screen always appears when the power is
turned on.)
The measurement screen varies depending on the number of components. The following screen
configuration is an example of NOx (1 component channel) and NOx, SO
component channels).
Example1: NOx (Component1 channel)
①
If there are more than 6 channels of components or more than 5 channels + peak alarm displays, you can scroll through them
with the
Figure 4.3
No.
1
Component
2
Concentration
3
Range
4
Unit
5
Range switching mode
Peak alarm component display
6
(*2)
7
Peak Alarm Count (*2)
8
Peak Alarm Unit Display (*2)
*1:
For NO, SO
the units are displayed in mass units (mg/m3 or g/m3). However, if the calibration gas concentration is specified in ppm, the
calibration gas concentration on the calibration-related screen will be displayed in both ppm and mass units.
*2:
Peak alarm-related displays are only shown when the Peak Alarm option (/A) is specified and the function is ON. (See 5.1.7
Peak alarm setting" for the function settings.
● Instantaneous concentration value:
②
③
⑤
④
icons.
Name
Component display of instantaneous value, O
instantaneous value, O
Display of measured concentration values
Display of range values
Indication of ppm, vol%, mg/m3 (*1)
Indication of how to switch between Range 1 and Range 2
CO Peak Alarm Component Indication
Indication of the number of times the peak value was exceeded
Peak alarm unit display
, and CO components, if each measuring range is specified in ppm and the option "/U" (Unit change) is selected,
2
Example2:
NOx、SO₂、 CO、 CO₂、 O₂
(Component 12 channel)
⑥
⑦
⑧
Function
-converted average value, etc.
2
g as component such as "CO
indicate what gas component is currently
being measured and each corresponding
instantaneous concentration value
4. OPERATION
, CO, CO
, and O
2
2
-converted
2
", "CO", "O
2
2
IM 11G06A01-02EN
1st Edition : Oct. 27, 2023-00
4-4
(12
2
"
Advertisement
Table of Contents
