P2A software
128
1
Click on [Test/analyze transmitter].
The Properties of <Instrument type> <Serial number> dialogue is
opened with the Test/analyze transmitter register.
2
Perform action:
Action
Carry out factory
reset:
Test analog
output:
Test switch
outputs:
Min./max. values
display:
3
Click on [OK] or [Cancel] to close the dialogue.
3.3.3.2
The required instrument file is marked.
1
Click on [Test/analyze transmitter].
The Properties of <Instrument type> <Serial number> dialogue is
opened with the Test/analyze transmitter register.
2
Mark Transmitter test.
Current operating hours are shown.
3
Confirm control query to perform the reset.
The values are reset to the customer-specific factory settings.
4
Click on [OK] or [Cancel] to close the dialogue.
- 3.3 Using the software
Explanation
Reset the unit, limit value and hysteresis parameters to
factory settings (see chapter 3.3.3.2).
Test channel 1/2/3 (optional) (see chapter 3.3.3.3).
Manually switch relays 1 to 4 to test for proper function
(see chapter 3.3.3.4).
Overview of the minimum and maximum values
measured since the last reset of the transmitter (see
chapter 3.3.3.5).
Carry out factory reset