Interrupt Task Registration; Figure 4-17 Enter Interrupt Task Window - Hitachi IR.LINK User Manual

4 OPERATION

4.3.3 Interrupt task registration

Function: Interrupt tasks are registered. Up to 8 tasks can be registered.
Operation: The procedure is shown below.
(1) On the [IR.LINK SYSTEM] window (Figure 4-2) or [ [S10V] IR.LINK SYSTEM] window
(Figure 4-3), click the
(2) The [Enter interrupt task] window is displayed (Figure 4-17).
When any interrupt task is already registered, the "Task number" and "Start factor" of the
corresponding interrupt input are displayed. In the unregistered status, the task number
field and the start factor field remain blank. The setting ranges for task number and start
factor are shown below.
<Setting ranges for task number and start factor>
Task number : 1 to 255 (decimal input) (Note)
Start factor: 0 to 32 (decimal input)
(Note) Task number 230 to 255 cannot start, because it is already used in the system.
<Interrupt task deletion>
To delete any interrupt task, make the task number field and the start factor field of the
corresponding interrupt I/O input blank and click the
(3) After completing the setting, click the
number and start factor. If it results in OK, register the interrupt tasks. If you do not want
to register them, click the
Enter interrupt task

Figure 4-17 Enter Interrupt Task Window

Cancel button.
button.
OK
OK button. Check the setting ranges for task
4-20
button.