Hitachi IR.LINK User Manual page 10

(chapter 3, page 3-3)
Dust or other foreign matter might accumulate on the connector, resulting in
poor contact. Immediately after the module is unpacked, perform the
mounting and wiring procedures.
To prevent the module from being damaged, observe the following precautions
when you mount or demount the module:
• Before mounting the module to the mount base connector, check that the
connector pins are properly aligned and not bent, broken, or soiled with dirt
or the like.
• Ensure that the module is parallel to the mount base vertical surface as
shown below when mounting. If you connect a module to or disconnect it
from its connector while it is tilted, the connector pins may become damaged.
• If the mount base is positioned overhead due to the employed enclosure
structure, use a stepladder or the like and mount the module squarely. If
you mount the module obliquely, the connector may become damaged.
Mount base
(chapter 3, page 3-4)
For the ground wiring of the FG (frame ground), connect the FG terminal of
each module with an external terminal to the FG terminal of the mount base.
Perform class D grounding from the FG terminal of the mount base.
Use a ground wire with a wire diameter of 2 mm
Connect the shielding wire of the communication cable to the SHD terminal of
the CPU or LPU module.
NOTICE
[Bad example]
Module
NOTICE
S-7
[Good example]
2
or more.